Tinkercad Instructional Video Script
Hi, welcome to my instructional video on how to make a small tv in tinkercad!
First you are going to go to the “geometric” category and click on the red box. Then, you’re going to shrink it down to 10 mm in height.
Next, you will stretch it out to about 80 mm in length. Now, widen the shape until you see 80 mm. Then, click the shape and take your mouse to color under “Inspector” at the top, now select black.
Now, here’s where it get’s a bit complicated. Now you will click the shape and press “ctrl” and press “c” at the same time, which will copy the shape you just made. Now press “ctrl” and “v”. This will paste the shape, and now you’ll have two of the same shapes.
Rotate the second shape until it sits at a “90 degree” angle. Now, drag the shape up so it overlaps the first shape. Then, press “ctrl” and “v”, another shape will appear, drag this to the side across from the overlapping shape.
Make sure it’s even with the shape across. Now, click the shape you just placed and press “ctrl c” then press “ctrl v”. Drag the shape between the two last two shapes you placed. Turn the shape until it’s at a 90 degree angle and then click color and change the shape to white. Inspect both sides of the standing black shapes to see if you see any white piercing through them. If so then click the white shape and hold shift, then drag the shape down until you see “75 mm”. Now, move the shape to the very edge of the middle shape lying beneath it.
Now turn you screen so you can see the back of all of these shapes, go over to the “geometric” column and click the box. Place the box between the black wall shapes.
Now hold shift and drag the shape up into you see “70 mm” Now turn your screen to the front of the shapes, and go over to the geometric column again, click “box”.
Bring the box in front of the shape, then drag it up until it is “20 mm” off the ground. Then, stretch the shape length to about “25 mm” Now make the length “65 mm”, click color and make the shape black. Turn the screen to the side of the shapes, make sure you can’t see the top of the screen (white shape) from that angle, now turn the screen back to the center. You now have a tv!
Reflection:
For my project I chose to create a TV in tinkercad. I'm not very experienced in tinkercad. I thought it would make sense to do my last project using tinkercad to get more experience out of it. It's pretty simple to use as long as you have the basics down. You also need to know what keys do what. You need to know where to find the shape you want. I used WeVideo to voice over on this clip. However, WeVideo wants money after a very short amount of time. I had to figure something out, and this was the outcome. I couldn't get the second half of the video due to WeVideo's money trap.
Just so you know I DO NOT recommend WeVideo it isn't very useful unless you're willing to spend money on it.
